FAQ

Modulo are the registered trademarks of our extensive line of manufactured stone veneer products. It is also the company name for the world's leading producer of manufactured stone.

Modulo products may be applied over any properly prepared, clean, untreated, structurally sound wall surfaces such as wood, wall board, masonry, or metal. See the Modulo Installation Instructions for details.

Modulo products are installed using Modulo Colle and Modulo Colle Extra over a properly prepared substrate. See Modulo Installation Instructions or website for complete details.

Yes. Details on application and substrates are given in the Modulo Installation Instructions and on our website.

The Exterior/Interior Modulo product range can be installed behind a freestanding stove if there is a minimum distance of 60 cm. Always refer to the fireplace or stove manufacturer’s installation instructions and local building codes.

Yes. Modulo products are easily cut and trimmed using a hatchet or wide-mouth nippers, or with a masonry blade used with a circular or masonry saw.

The Exterior and Interior Modulo product ranges are suitable for both, and allow you to bring the outdoors inside, emphasizing design and continuity in colour and texture. The Interior Modulo product range is suitable only for Interior installation.

Possibly, just as natural stone or brick will. Sealing the Modulo products facing of a fireplace installation will assist in the removal of smoke stains should they occur.

No. Modulo wall products are not suitable for foot traffic. However, our floor range pavers may be used for walkways and patios for pedestrian traffic only.

The Modulo Exterior product range will perform from a durability standpoint in the same manner as any quality lightweight concrete material. However, it should be noted that as with any concrete or natural material, continued exposure to chlorine and...

Modulo products are manufactured stones with the additional advantages of lightweight and ease of installation.

Modulo products are cast in moulds taken from carefully-selected natural stone, using a process that faithfully captures even the faintest detail. Each colour and texture uses its own blend of cement, lightweight natural aggregates and iron oxide pigments...

Modulo products installed cost is usually much lower than the installed cost of natural stone. Modulo products require no additional footings, foundations or wall ties, and installation time will be considerably less than when using natural stone or ...

Flat pieces are sold by square meter. Corner pieces by linear meter and accessories are sold by piece.

Flat Modulo products are available in various package types: for example, flat stones come in carton boxes on a pallet and the area covered is stated on the website. Other packaging varies for corners, specific textures and accessories.

The weight of Modulo products varies greatly by product and is approximately 14 to 37 kg per square meter.

Colours become an integral part of the Modulo products during the casting process. Existing applications show no undesirable change in colour after years of weathering in various climatic exposures.

Base colour is blended throughout the entire product. Colour overtones are applied and integrated into the product during the casting process.

Modulo products are cast from many individual moulds, essentially eliminating repetition. In addition, to further eliminate the possibility of repetition, we use manual colouring, thus further reducing the risk for same stones with the exact same colouring...

As Modulo products are made of composite materials and will last at least a decade. Modulo products carry a 2-year limited warranty.